Cushion Rubber Adhesive
For most smaller tables, the rubber should be stuck directly on to the timber of the cushion using high impact adhesive suitable for rubber. We have made some Neoprene impact adhesive which is perfect for this job available below. Superglue and other types of glue will not work properly.
Apply to both surfaces, wait a few minutes and then press surfaces together, shaping the rubber around the corners of the pockets.
We also can supply a roll of cushion rubber tape if desired. This is sometimes used on larger tables along the join of the top of the rubber and the wooden cushion before pulling the cloth over both.
The technology for cushions on full size snooker tables is more complex and fitters are advised to refer to the manufacturer for further details if necessary.
Neoprene Cushion Rubber Adhesive - 1/2 Litre can
Made in Britain
A 1/2 Ltr tin of Neoprene Cushion Rubber Adhesive. Used for fitting cushion rubbers onto Billiards, Snooker & Pool table.
Roll of Billiard Table Cushion Tape (50mm wide)
- A reel of cushion tape that is 50mm wide and suitable for most tables that use it
- 50m roll
Made in Britain
Some larger tables use cushion tape to help hold the billiard cushion rubber to the top surface of the wooden cushions.
We are not billiard table fitters so cannot offer full advice but we understand that this cushion tape is pressed along the top face of the rubber and the adjacent wooden cushion thus helping to hold the two together and also keeping the rubber against the cushion in the correct place. The cloth is pulled over the top of both the rubber and the tape.
This is a reel of cushion tape that is 50mm wide and suitable for most tables that use it. It is not suitable for steel block cushions which require a slightly wider tape.